Back to Blog
Altium designer 15 wpi install5/19/2023 High quality USB cable is needed for this board to give high current supply, otherwise your board won’t be recognized. To flash R2, please see the update on Nodemcu wiki page. Note: NO need to install driver for CH341 (replaced by CP2102), and NO need to flash firmware when you get it and use on first time. Headers – 2x 2.54mm 15-pin header with access to GPIOs, SPI, UART, ADC, and power pins.USB – micro USB port for power, programming and debugging.Wi-Fi Module – ESP-12E module similar to ESP-12 module but with 6 extra GPIOs.Power your development in the fastest way combine with NodeMCU Firmware! R2 version had CP2102 USB-TTL instead, larger current support, slim board can put on breadboard. The Development Kit based on ESP8266, integrates GPIO, PWM, IIC, 1-Wire and ADC all in one board.
0 Comments
Read More
Leave a Reply. |